Siemens 810T manual 228, 3000, 3001, 3002, 3003

01.93	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	228*
Alarm Text:	ºOption M19 missingº
Alarm No.	M19 S... was programmed in the part program although this function is
	not implemented in the control.
Alarm Text:	·	Check program
	·	Check NC MD
	· Upgrade with option E42
Alarm No.	3000
Alarm Text:	ºGeneral program errorº
Reason:	± In one block of the program, a general, not precisely definable,
		programming error was made.
		Example: ±	An axis was programmed that is not present on the
			machine
		±	An incorrect interpolation parameter was programmed
	±	ºAxis duplicationº option is active and D number in the part program
		> 49.
Remedy:	± Check the faulty block in ºCorrection blockº.
		If possible, the cursor is positioned in front of the word containing
		the error. The number of the block containing the error is displayed
		in the alarm line after the alarm No.
	±	Change part program
Alarm No.	3001
Alarm Text:	ºGeometry parameters > 5º
Reason:	More than 5 geometry parameters, such as axes, interpolation
	parameters, radii, angles have been programmed in a block.
Remedy:	As for alarm 3000
Alarm No.	3002
Alarm Text:	ºPolar / radius errorº
Reason:	In a block with polar/radius programming:
	±	no angle
	±	no radius
	±	no coordinates for the centre point have been programmed
Remedy:	As for alarm 3000
Alarm No.	3003
Alarm Text:	ºInvalid addressº
Reason:	± Axis duplication active and axes of tool system 2 programmed in the
		part program.
	±	An address has been programmed that is not defined in machine
		data.
Effect:	NC START inhibited.
Remedy:	Change part program.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-25

SINUMERIK 810T, GA3 (BN)