Siemens 810T manual ± Z, ± Q, Continuous mode, Function of the direction keys

2 Operation 11.90

2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

Continuous mode:

When the direction key is pressed (whether you press for a short or long time), the axis only traverses one increment (1/ 10/ 100/ 1000/ 10000µm, depending on the setting).

Jog mode:

The axis traverses as long as you press the direction key. Traversing stops when you release the key. This also happens if the set increment has not been reached

It is defined in machine data whether the axes are

traversed using the direction keys in either:

-continuous mode or

-jog mode.

Function of the direction keys

+X

± X

+Z

± Z

+Q

± Q

With this key you traverse the ºXº axis

With this key you traverse the ºXº axis in the opposite direction

With this key you traverse the ºZº axis

With this key you traverse the ºZº axis in the opposite direction

With this key you traverse the ºQº axis (Auxiliary axis)

With this key you traverse the ºQº axis in the opposite direction

Rapid traverse override:

When you operate this key at the same time as any of the keys above, the axis is traversed at rapid speed.

The rapid traverse speed is defined in a machine data.

2-20 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)