Siemens 810T manual Display of tool data, Tool Offset Geom Data

09.91 3 Operating Sequences

3.1.4 Tool offset

Enter the geometry data in this screen form. Note that the location number in the magazine table (e. g. 3) is the same as the D No. of the tool offset memory (e. g. D3).

Press the ªGEOMETRY DATAºsoftkey to return to the ºTOOL OFFSET º menu. You can return to the standard menu by pressing the ªRECALLº key twice

If you are entering tool data from paper tape, observe the instructions of the machine manufacturer.

3.1.4.7 Display of tool data

TOOL

OFFSET

GEOM.

DATA

or

D...

Press either ªTOOL OFFSETº softkey or the ªGEOMETRY DATAº softkey.

Press the approriate keys to page through the display and select a certain D No. input is then displayed.

or

Select a D No. and press the search key. The tool data under the D No. input is then displayed.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-15

SINUMERIK 810T, GA3 (BN)