Siemens 810T manual Delete Param Store

11.90

... ...

· · ·

3 Operating Sequences

3.1.11 Contour

Now enter the first value using the numerical keys; then store it using the input key.

The inverse video marking now jumps to the next input field for the contour: the control now waits for your next input...

.	.
.	.
.	.
etc.	etc.

Now enter, one after the other, the rest of the geometry values into all of the input fields of the contour marked in inverse video - as described above.

X

Z

DELETE PARAM.

STORE

Using the cursor keys, you can position the inverse video marking to any input field, if, for example, you wish to modify the geometry values for the selected contour.

Note:

Note the input fields marked in inverse video on the CRT display, in curly brackets, in which there are several values

(ºXº and ºZº in example).

In this case you are only allowed to enter one value (i.e. only the X value or the Z value, in the example).

If you have inadvertently entered two values, operate the ºDELETE PARAMETERº softkey.

When you have entered all the values required for the contour, operate the ºSTOREº softkey.

The contour definition is now stored in the part program with all the entered values. The control generates the ºBlock endº (LF) character itself, and shows you the complete block entered.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-53

SINUMERIK 810T, GA3 (BN)