Siemens 810T manual Operating Sequences 09.91 Axis synchronization

3 Operating Sequences 09.91

3.1.8 Axis synchronization

Case 1: The tool system 1 axis and the tool system 2 axis have the same offset. Both axes are traversed synchronously after you have pressed the traverse key for the leading axis (tool system 1).

Case 2. The tool system 1 axis and the tool system 2 axis have different offsets. You can only eliminate offsets by traversing the axes separately. Press the appropriate traverse keys on the machine control panel (see the note in the box on this page!).

Case 3: Press ªNC startº and the offsets are eliminated simultaneously on all axes.

By offsets we mean all additional differences in axial position between the machine zero and the workpiece zero, which are not contained in the position instructions of the part program. The following four offsets exist separately for the leading and the following axes:

±settable ZO G54-G57

±external ZO

±DRF offset

±PRESET offset.

If your machine control panel does not possess traverse keys for the tool

system 2, please consult the machine manufacturer.

Note:

If ªaxis synchronizationº is selected, the following axis is always traversed together with the leading axis (tool system 1), as long as the movements are programmed!

3-36 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)