Siemens 810T manual Dry Run Yes-No, Output of the end of block character end of text

09.91 2 Operation

2.5 Glossary of softkey functions

DRY RUN YES-NO

With ºYESº, the axes are traversed at the dry run feedrate, not the programmed feedrate. The dry run feedrate is set via setting data.

EDIT

EDIT leads to ºSELECT PROGRAMº, ºGUIDINGº and ºSIMULATIONº.

Editing means:

±Input of a program into the memory or changing or altering a program already in the memory.

ENABLE

You can enable the handwheel for the selected axis with this softkey.

ETX START

Output of the end of block character (end of text)

FEED

You select the G functions for the type of feed via softkey. Preselect: softkey ºGUIDINGº.

G FUNCT.

You select the G functions from groups G 0 to G 12 via softkeys (see Programming Guide). Preselect: ºGUIDINGº softkey.

GUIDING

The operator guiding (operator prompting) function speeds up and simplifies the input of part programs.

Apart from geometric functions (G function, contour definition) you can also input machining cycles and technological functions (feedrate, spindle speed) via softkeys.

HANDWHEEL

In the INC 1...INC 10000 operating mode you activate an electronic handwheel via softkeys. The electronic handwheel enables operation which is equivalent to jog handwheel operation.

HW VERSION

You can display the hardware data by operating this softkey.

Preselect: DIAGNOSIS and SW VERSION softkeys.

INPUT DISPLAY

To call up the input displays with corresponding operator guidance macros configured by the machine tool manufacturer from the user memory submodule. Please refer to the information supplied by the machine tool manufacturer for the actual menus, display descriptions and operating sequences.

LINE

You select the G functions for linear interpolation by means of a softkey.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-67

SINUMERIK 810T, GA3 (BN)