Siemens manual Bild 810T/33 einmontieren, ªprogram Controlº, Program Control, Simula Tion

09.91

	1	6
%	F	K

SELECT SIMULA- PROGRAM TION

3 Operating Sequences

3.1.14 ªSIMULATIONº

Using the numerical keyboard, enter the desired program number º% ...º (or ºL...º)- º% 16º in the example.

Operate the ºSELECT PROGRAMº and ºSIMULATIONº softkeys one after the other.

Using the ETC key, extend the displayed softkey menu.

The new softkey menu shows two possible selections described below under a) and b):

PROG.

CONTROL

BLOCK SEARCH

a)b)

a)ªPROGRAM CONTROLº

PROGRAM

CONTROL

When you operate the ºPROGRAM CONTROLº

softkey...

... the relevant CRT display is shown. You can alter the simulation ºStatusº using a softkey, by selecting the desired function and setting to ºYESº.

((Bild 810T/33 einmontieren))

SIMULA-

TION

Now operate the ºSIMULATIONº softkey again, and then operate the ETC key to extend the displayed softkey menu.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-75

SINUMERIK 810T, GA3 (BN)