Siemens 810T manual Term Section

8 Appendix	09.91
8.2 List of terms used

Term	Section
Reset with change of mode	2.3.4
ROTAT. ANGLE	2.5
R PARAMETER	2.5
R Parameter	3.1.6
R Parameter setting data	3.1.6
SCALE MODIF.	2.5
Scratching	3.2.13
Search address, block no., word or data	2.1.1.5
Semi-automatic tool compensation offset	3.1.4.4
Semi-automatic zero offset	3.1.5.3
SERVICE AXIS	2.5
SERVICE DRIVE	2.5
SERVICE SPINDLE	2.5
Settable zero offset	3.1.5.1
SETTING DATA	2.5
Setting data	3.1.5/3.1.6/6.4/6.3
SIMULATION	2.5
Simulation	3.1.14
Single block	2.1.1.6/2.1.2.1
SINGLE BLOCK	2.5
SKIP BLOCK ON/OFF	2.5
Softkey functions	2.5
Softkeys	2.1.1.1
SPECIAL BLOCK	2.5
SPECIAL FUNCT.	2.5
SPINDLE	2.5
Spindle setting data	3.1.6
Spindle speed	2.1.1.6
Spindle speed override	2.1.2.1
Spindle stop/spindle start	2.1.1.6/2.1.2.1

8-8 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)