Siemens manual 810T Bild 42 von Druckerei einmontieren, Current Block

3 Operating Sequences 09.91

3.2.2 ºAUTOMATICº operating mode - selection of the ºCURRENT VALUESº or ºCURRENT BLOCKº display

CURRENT

BLOCK

Operate the ºCURRENT BLOCKº softkey.

(( 810T))

(( Bild 42 von Druckerei einmontieren

The ºCURRENT BLOCKº display for the active program appears - program º % 88 º in this example.

Explantion of the ºCURRENT BLOCKº display

In addition to the displays already mentioned (ºCURRENT VALUESº), the following are displayed:

·The block before the ºcurrent blockº, here block ºN 5º

·The ºcurrent blockº, here block ºN 10º

·The block after the ºcurrent blockº, here block ºN 15º.

Instead of the actual positions of the individual axes as shown in the ªCURRENT VALUESº display, the current G functions are listed here.

Note:

If the ºcurrent blockº consists of more than 41 characters, the following block is not displayed!

Likewise, a block before or after the ºcurrent blockº with more than 41 characters is not displayed.

User generated cycles are still displayed under ªCURRENT BLOCKº after

a cycle disable.

3-92 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)