Siemens 810T Feed or rapid traverse override decrease / increase, To or from peripheral devices

11.90 2 Operation

2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

Feed or rapid traverse override decrease / increase

The two keys make it possible for you to decrease or increase the programmed feedrate value ºFº (with reference to 100% value). The value set with these keys is displayed as an absolute value and as a percentage.

Operate the

key quickly.

The feedrate is decreased in the following steps:

± by		5%,	in the feed range	120 %	to	70 %
± by 10%,			in the feed range	70 %	to	10 %
±	by	2%,	in the feed range	10 %	to	2 %
±	by	1%,	in the feed range	2 %	to	0 %

Continuous operation causes the feedrate to be decremented in steps until the end value 0% (standstill) is reached.

Operate the

key quickly.

The feedrate is increased in the following steps:

± by		1%,	in the feed range	0 %	to	2 %
± by		2%,	in the feed range	2 %	to	10 %
±	by 10%,		in the feed range	10 %	to	70 %
±	by	5%,	in the feed range	70 %	to 120 %

Continuous operation causes the feedrate to be incremented in steps until the end value 120% is reached.

The increments specified apply to standard machine

data.

Socket connector for universal interface
14	1	Beneath the cover hinged on the left, you will find a 25-pole socket
	o
o	o	for D-type sub-miniature connectors.
o
o	o
	o
o
	o
o		Via this V.24 (RS232) / 20 mA interface, you can transfer serial data
	o
o
o	o	to or from peripheral devices.
	o
o
o	o
	o
o
	o
o
	o
o
	o
25
	13

For details of transmission data see Section 6.3 (Setting data), and for device connection see Section 6.4 (Device connection data).

For details of the correct cables see: ºSINUMERIK System 800º, Configuring Instructions / Universal Interface.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-23

SINUMERIK 810T, GA3 (BN)