09.91

3 Operating Sequences

3.1.6 Setting data: ºR PARAMETERSº, ºSPINDLEº, ºAXIALº, ºANGLE OF ROTATIONº, ºSCALE MODIFICAT.º

7

X

=

H

1

F

To do this enter the axis name, e.g. ªXº, and assign the number of the handwheel, e.g. ª1º, to it.

You can also assign several axes to a handwheel, but you can only ever enable one axis for this handwheel (for further details, see ªHANDWHEELº in Section 3.2.9 for ªDRFº in Section 3.2.10).

Press the softkey ªWORKING AREA LIMº to return to the display for the minimum and maximum working area limitation.

ºANGLE OF ROTATIONº setting data

Sequence of operation for ºANGLE OF ROTATIONº setting data

SETTING

DATA

Operate the ºSETTING DATAº softkey in any operating mode.

Extend the softkey menu displayed using the ETC key to the right below the display.

ROTAT.

ANGLE

Operate the ºROTAT. ANGLEº softkey.

The SETTING DATA COORDINATE ROTATION input screen form appears in the ªAUTOMATICº mode.

Enter the desired angle of rotation A... for G54 to G57 in this screen form (the angles of rotation A... for G58 and G59 are defaulted by the program and only displayed in the screen form).

Then proceed as follows:

With the cursor keys, position the cursor at the desired input field (G54 ... G57).

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

3-31

SINUMERIK 810T, GA3 (BN)

Page 132
Image 132
Siemens 810T manual Sequence of operation for ºANGLE of ROTATIONº setting data, Rotat Angle