Siemens manual Sinumerik 810T machine data General machine data, Diag Nosis

7 Interfacing to the Machine 09.91

7.3 SINUMERIK 810T machine data

7.3SINUMERIK 810T machine data

7.3.1General machine data

In this section you will find tables of machine data, whose values can be changed from the standard values by the machine tool manufacturer at any time.

In the

Set value

column you can enter the value displayed on the CRT of the control

delivered.

You must only check the machine data displayed, you must not modify them.

To call up the CRT display, proceed as follows ...

Sequence of operation: Calling general machine data

Operate the mode selection key on the integrated machine control panel, and then any operating mode softkey.

or select any operating mode using the mode selector switch (external machine control panel).

DIAG-

NOSIS

Operate the ETC key to extend the softkey menu, and then the ºDIAGNOSISº softkey.

7-4 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)