Siemens 810T Bild 54 von Druckerei einmontieren, Continuing Teach in / Playback after Reset

11.90

(( 810T))

(( Bild 54 von Druckerei einmontieren

...

N · · ·

3 Operating Sequences

3.2.6 ªPLAYBACKº

This display shows an example of a block ºN1º, entered using ºPLAYBACKº.

Operate the ºProgram startº key after each block is entered.

This transfers the block to the program memory.

Blocks not required can be deleted by entering the block no. º N...º, and operating the delete key. Blocks traversed correctly remain - as entered - in the memory.

After each ºRESETº using this key, the pro- cessing of the program can be repeated.

Continuing TEACH IN / PLAYBACK after RESET

Set the mode selector switch to the symbol for ºAUTOMATICº.

... ...

% · · ·

PART	TEACH IN
PROGRAM	PL.BACK

and

Enter the desired part program number º%...º in the ºAUTOMATICºbasic display and store it with the input key.

Then operate the ºPART PROGRAMº softkey followed by the ºTEACH IN / PLAYBACKº softkey.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-119

SINUMERIK 810T, GA3 (BN)