Siemens 810T manual Moving a program ºMOVEº, Part Prog Program Handl Move

3 Operating Sequences 11.90

3.1.13 Program management

3.1.13.5 Moving a program (ºMOVEº)

Using the ºMOVEº function, you can move the program selected to the end of the memory.

While another program is being processed, only the program at the end

of the memory can be modified.

Sequence of operation

PART PROG.-

PROGRAM HANDL.

MOVE

	...
%		· · ·

Operate the ºPART PROGRAMº and ºPROGRAM HANDLINGº softkeys, one after the other, in any of the operating modes:

PRESET / JOG / AUTOMATIC /

INC1... ICN10 000/ REFPOINT

Using the keyboard, enter the desired program no. º%...º (or ºL...º), and operate the ºMOVEº softkey.

The program selected is moved to the end of the memory.

Note:

If the cycle lock has been cancelled by the PLC you can copy a cycle from the EPROM to the end of the program memory with the ºMOVEº function. You can then edit the cycle like a normal part program.

As the cycle now exists twice under the identical no.L (in the EPROM and the program memory), the cycle in the EPROM is marked in the directory with an (*). The cycle in the program memory has priority on selection.

The cycle in the EPROM can be called again with the ºSELECT PROGRAMº softkey, when the respective cycle has been deleted from the program memory.

3-62 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)