Siemens 810T manual ETX Start

11.90 3 Operating Sequences

3.1.15 Data input/data output

1	or	2	or
F		D

START

0

S

Using the keyboard, enter the channel no.:

into the input field marked in inverse video:

º1º for output of local

R parameters, channel 1 º2º for output of local

R parameters, channel 2 º0º for output of the

global R parameters

Start the output of the R parameters by operating the ºSTARTº softkey.

STOP

Using this softkey, you can stop data output at any time...

and continue it again with ºSTARTº.

In the same way, you can select and start the output of data for the following:

±ºTOOL OFFSETº

±ºZERO OFFSETº

±ºMACHINE DATAº

±ºPLC MACHINE DATAº

which have not been detailed here.

ETX

START

With the ºETX-STARTº softkey you can output the end- of-transmission character stored in the setting data. The output is always made irrespective of whether RTS line or Xon/Xoff protocol have been set.

Note:

·A selection of the data, i.e. the output of a section as with ºPART PROGRAMº - is not possible!

·The input of a channel no. is only required by the control for ºR PARAMETERSº.

·Data output with or without leader or trailer can be set via setting data (SD 5016, bit 1).

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02	3-85
SINUMERIK 810T, GA3 (BN)