Siemens 810T manual 2031, 2032, 2034, 2035, 2036, 2037, 2038

01.93	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	2031
Alarm Text:	ºEval. (weighting) factor too high (MD 388*)º
Remarks:	Alarm only on commissioning
Alarm No.	2032
Alarm Text:	ºStop during threadingº
Reason:	During thread cutting, the feed per revolution was stopped, and the
	thread destroyed.
Effect:	Inhibiting of NC START
Alarm No.	2034
Alarm Text:	ºSpeed reduction areaº
Reason:	The software pre-limit was overshot, and the axis decelerated to the
	reduced traverse rate
Remedy:	Check the program
Alarm No.	2035
Alarm Text:	ºFeed limitationº
Reason:	The programmed feedrate is higher than the contouring feedrate,
	based on the maximum feedrate of the axes.
Remedy:	Program a lower contouring feedrate
Alarm No.	2036
Alarm Text:	ºG35 thread pitch decr. errorº
Reason:	The pitch decrease in threading is so high that at the end of the thread
	a diameter of less than, or equal to zero would result.
Remedy:	Program either a smaller pitch decrease or a shorter thread
Alarm No.	2037
Alarm Text:	ºProgrammed S value too highº
Reason:	The programmed spindle speed ºSº is higher than º16000º.
Remedy:	Program a smaller spindle speed (the S value is limited to º16000º
	within the control).
Alarm No.	2038
Alarm Text:	ºPath feed too largeº
Reason:	Axis velocity too great because of the programmed path velocity.
Effect:	NC START disabled and setpoint relay drops out.
Remedy:	Observe permissible value range.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-15

SINUMERIK 810T, GA3 (BN)