Siemens 810T manual 2064, 2065, 2066, 2067, 2068

11.90	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	2064
Alarm Text:	ºProgram error round (rotary) axisº
Reason:	If you round to either a half or full degree on a circular axis, the control
	will monitor whether the programmed positions correlate with the
	rounding.
Effect:	± Inhibiting of NC START
	± The programmed move in the block is not executed.
Remedy:	Program the correct rotary axis position
Explanation:	In the JOG, INC modes, the control automatically rounds to valid
	values. In the AUTOMATIC or MDI AUTOMATIC modes, the control
	only monitors the programmed positions, without rounding itself.
Alarm No.	2065
Alarm Text:	ºPosition behind SW overtravel switchº
Reason:	The programmed block end-point lies behind the software limit switch.
Effect:	± Inhibiting of NC START
	± The programmed move is not executed
Remedy:	Correct program
Alarm No.	2066
Alarm Text:	ºThread lead increase / decreaseº
Reason:	A thread lead increase or decrease of more than 16 mm / rev
	(0.6 inch/rev) has been programmed.
Effect:	Inhibiting of NC START
Remedy:	Program a smaller thread lead increase / decrease
Alarm No.	2067
Alarm Text:	ºMax. speed =0º
Remarks:	Alarm only on commissioning
Alarm No.	2068
Alarm Text:	ºPos. behind working areaº
Reason:	The programmed block endpoint lies, in one or more axes, outside the
	working area limits.
Effect:	± Inhibiting of NC START
	± The programmed move is not executed
Remedy:	± Check working area limits (plus and minus)
	± Alter working area limits in program with G25/G26

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-19

SINUMERIK 810T, GA3 (BN)