Siemens 810T manual 3.3 ºBLOCK SEARCHº, Auto Matic Block Search

11.90 3 Operating Sequences

3.2.3 Influencing ºAUTOMATICº operation

3.2.3.3 ºBLOCK SEARCHº

The ºBLOCK SEARCHº function allows entry into a program at any desired point. In the ºBlock searchº display, you enter the program and the block number.

A block search is also possible in nested subroutines. Enter in the main program the number of the block in which the subroutine call is programmed. After this, enter the subroutine number, the pass count, and the block number of the subroutine.

During the block search operation, the same calculations are carried out as in normal program operation although the axes are not traversed

Output of the auxiliary functions during ªblock searchº

can be defined in machine data.

Depending on the setting at the time of installation, the H, M, S and T functions are output completely, partially or they are suppressed entirely.

Sequence of operation

AUTO-

MATIC

and

or

BLOCK

SEARCH

Operate the ºRESETº key on the machine control panel.

Operate the operating mode selection key on the integrated machine control panel, and then the ºAUTOMATICº softkey, or ...

... set the operating mode selector switch on the external machine control panel to this symbol.

Extend the displayed softkey menu, and subsequently select the ºBLOCK SEARCHº softkey function .

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-101

SINUMERIK 810T, GA3 (BN)