Siemens 810T manual 2046, 2047, 2048, 2056, 2057, 2058

09.91	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	2046
Alarm Text:	ºBlock greater than 120 charactersº
Reason:	There is an incorrect ºLFº in the memory, so that a block containing
	more than 120 characters exists.
Effect:	Inhibiting of NC START
Remedy:	Either insert ºLFº, or delete the complete block
Alarm No.	2047
Alarm Text:	ºOption not availableº
Reason:	A function was programmed that is not included in the function set of
	the control.
Effect:	Inhibiting of NC START
Remedy:	Correct program
Alarm No.	2048
Alarm Text:	ºCircle endpoint errorº
Reason:	The programmed circle endpoint does not lie on the circle.
	The tolerance band set in machine data is exceeded.
Effect:	Inhibiting of NC START
Remedy:	Correct program
Alarm No.	2056
Alarm Text:	ºTravel through transf. centerº
Explanation:	± On the programmed contour, the radius axis (linear axis) wants to
		traverse into the zero of the fictitious coordinate system.
Remedy:	±	Change cutter radius.
	±	Program a different contour.
Alarm No.	2057
Alarm Text:	ºOpt. thread/rev. not avail.º
Reason:	± A thread has been programmed in the program with G33, G34, G35
		although this function is not available in the control
	±	Feed per rev. G95 has been programmed.
Remedy:	Correct program.
Explanation:	Alarm with SINUMERIK 810M only.
Alarm No.	2058
Alarm Text:	º3D option not avail.º
Reason:	In the program, 3 axes were programmed simultaneously
Remedy:	Correct program
Explanation:	Alarm with SINUMERIK 810M only

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-17

SINUMERIK 810T, GA3 (BN)