Siemens 810T manual Deleting all offset values in an offset number D, Sequence of operation

3 Operating Sequences 11.90

3.1.4 Tool offset

3.1.4.3Deleting all offset values in an offset number D ...

a) You would like, for example, to delete all values stored under tool offset number ºD5º

Sequence of operation

5

J

Using the key you enter º5º.

You operate the ºDelete word/blockº key.

When you now select the tool offset number ºD5º, using either the ºPage up /downº
keys	, or by entering the number º5º and operating the search key	, you
can check that all the values in this offset number have been set to ºzeroº.

b)You would like, for example, to delete all stored values under tool offset numbers ºD4º to ºD9º.

Sequence of operation

4

L

=

H

9

Z

Using the keys you enter º4 = 9º.

You operate the ºDelete word/blockº key.

When you now call the tool offset numbers ºD4º to ºD9º, as described in a) above, you can check that all offset values have been set to ºzeroº.

3-10 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)