Siemens 810T Bild 53 von Druckerei einmontieren, Handwheel, Enable of the handwheels connected

09.91 3 Operating Sequences

3.2.9 ºHANDWHEELº

Extend the displayed softkey menu using the ETC key.

HANDWHEEL

Select the ºHANDWHEELº softkey function.

This display appears on the screen.

(( 810T))

(( Bild 53 von Druckerei einmontieren

The screen display shows you the axis-handwheel assignment which you have set via the axial setting data (see Section 3.1.6).

Enable of the handwheels connected:

ENABLE	Enter the axis name (e.g. ªXº) and press the
	ªENABLEº softkey. The ªENABLEº display changes
	from ªNOº to ªYESº. Now handwheel No. 1 applies
	to axis ªXº. Proceed in an analogous manner for the
	other axes (see also Section 3.2.10 ªDRFº).

If one handwheel is assigned to several axes by the axis setting data, the enable always appli- es to the last axis to have been input. On the display, the enable for the other axes automa- tically changes to ªNOº, i.e. the axis is blocked for the handwheel.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-125

SINUMERIK 810T, GA3 (BN)