Siemens 810T manual ± Z ± Q, 7 ºJOGº mode

09.91 3 Operating Sequences

3.2.7 ºJOGº mode

3.2.7ºJOGº mode

In this mode, machining is performed via the NC in JOG/manual mode, but it is not programmed.

You traverse the axes with the direction keys.

The traversing speed is defined in machine data.

Sequence of operation

JOG

or

Operate the operating mode selection key in the integrated machine control panel, and then the ºJOGº softkey or ...

... set the operating mode selector switch in the external machine control panel to this symbol.

	+X	+Q
± Z		+Z
± Q	± X

By operating the direction keys, you cause the axes to traverse in ºjogº mode!

You can traverse a maximum of 2 axes at the same time.

The red ºFeed holdº LED display, must not be bright during the sequence of operation.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-121

SINUMERIK 810T, GA3 (BN)