Siemens 810T Definition of the initial setting of the G groups, Press the ªDIAGNOSISº softkey

09.91 7 Interfacing to the Machine

7.3.4 Definition of the initial setting of the G groups

7.3.4Definition of the initial setting of the G groups

Previously the initial settings for the G groups 0/2/3/5/7/9/10/11 and 13 were defined permanently (For G group allocation see Section 12).

Now you can define the initial setting of

G groups 0/2/5/7 and 11

channel-specifically.Simply enter the number of the G function you want to be the initial setting in the channel data.

Exception:

The initial setting G70/G71 is still entered in machine data 5002, bit 4.

Sequence of operation

DIAG-

NOSIS

Press the ªDIAGNOSISº softkey.

NC MD	CHANNEL
	DATA

Extend the menu displayed with the ETC key and press the ªNC MDº softkey.

Extend the softkey menu again and press the ªCHANNEL DATAº softkey again.

A display with the channel-specific machine data MD 1000 to 1019 appears.

Use the ªpage downº key to page through the display until the machine data up to 1199 appear. Now you can enter the initial settings of the above G groups directly into MD 108* to 118* (2nd steps).

Four input fields are available to you. In the first two (from left to right) of each you define the channel-specific (1st and 2nd channel) initial setting of the G group assigned to the machine data.

Inputs in other input fields cause the alarm message ªGeneral data errorº. The allocation of NC MDs to G groups or G functions are to be found in the overview on the next page.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 7-9

SINUMERIK 810T, GA3 (BN)