Siemens 810T manual 5 ºTEACH INº, Part Teach Program PL. Back

3 Operating Sequences 11.90

3.2.5 ºTEACH INº

3.2.5ºTEACH INº

Using the ºTEACH INº function in the ºAUTOMATICº operating mode you can generate a part program on a block-by-block basis.

You can test the program immediately

Sequence of operation

AUTO-

MATIC

and

or

Operate the operating mode selection key on the integrated machine control panel, and then the ºAUTOMATICº softkey

or...

... set the operating mode selector switch on the external machine control panel to this symbol.

...

%

PART	TEACH IN
PROGRAM	PL. BACK
and

Enter the desired program no. º% ...º (or subroutine no. ºL ...º) in the ºAUTOMATICº basic display.

Operate the ºPART PROGRAMº and ºTEACH IN/PLAYBACKº softkeys, one after the other.

The selected part program no. with the input pointer below it are displayed.

	...
N
	...
G
7	...
X

+

LF

Using the numerical keyboard, enter a block (or more than one block) following the guidelines in the Programming Instructions, and terminate each input - including ºLFº (end of block) - with the input key.

Note :

You can also work with operator - ºGUIDINGº (see Section 3.1.10.2).

The part program is entered directly into the part program memory.

3-116 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)