Siemens 810T manual Clear PRE-OFF

3 Operating Sequences 01.93

3.2.11 ºActual value settingº mode (ºPRESETº)

The new ºActual positionº and the ºPRESET offsetº for the X axis are displayed.

In the same way you enter the values for the other axes, and subsequently operate the ºSTOREº softkey after input for each axis.

2. ºPRESET offsetº with inclusive calculation of the tool offset

...

...

Using the keyboard, enter the desired tool offset number D ... into the ºCompensation numberº input field,

and store it using the input key.

2

D

Using the keyboard, enter the identification ºIdent. No.º (see Section 3.1.3) for the X axis into the ºIdent no.º input field - º2º in the example.

Store it using the input key.

Use the same method to enter the identification no. for the other axes.

STORE

7	=
X	H

First enter the designation of the desired axis (ºXº for the X axis in this example). Then assign this axis the corresponding value of the ºPRESET offsetº using the numerical keys and finally operate the ºSTOREº softkey.

The new ºActual positionº and the ºPRESET offsetº for the X axis are displayed. The displayed value of the ªPRESET offsetº comprises:

±the entered value

±plus: the calculated tool offset.

CLEAR

PRE-OFF

You can clear all the ºPRESET offsetsº at once by operating the ºCLEAR PRESET- OFFSETº softkey.

3-130 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)