Siemens 810T manual Special Block

09.91 2 Operation

2.5 Glossary of softkey functions

SERVICE

In this display, all the axis service data are displayed.

With the ºPageº key you can switch to the desired axis.

SERVICE DRIVE

All data required for servicing the integrated drive control (IAR) are shown in the display obtain- ed by pressing this softkey.

However the hardware for the IAR is not implemented on the GA3, SW2.

SERVICE SPINDLE

All data required for servicing the spindles are shown in the display obtained by pressing this softkey. You can switch to the spindle required with the ªpage downº key.

SETTING DATA

Using setting data, the operator (user) fixes certain operating states. Setting data are adjust- able for:

±Programmable and settable zero offsets

±External zero offsets

±R parameters

±Spindle data

±Axial data

±Angle of rotation

±Scale modification

±Data transfer

±General data (setting data bits).

SIMULATION

To test the program the programmed movements are shown on the CRT display. Programming errors are displayed as alarms.

SINGLE BLOCK

After ºProgram startº only one block is processed. The next block is only processed after another operation of ºProgram Startº.

SKIP YES-NO

With ºYESº selected, the blocks marked with an oblique (/) are skipped during program processing (Program control).

SPECIAL BLOCK

You select G04, G92, M19, G58, G59, G50 and G51 with this softkey.

SPECIAL FUNCT.

The special functions M00, M01. (1st M Group) and M 36, M37 (4th M Group) are grouped together in this function.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-71

SINUMERIK 810T, GA3 (BN)