Siemens 810T manual 2078, 2081, 2082, 2087, 2088, 2089, 2152

09.91	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	2078
Alarm Text:	ºIncorrect input parameterº
Reason:	± Programmed parameter sequence not allowed
	± Parameter sequence not complete for the described contour
Effect:	As for alarm 2072
Remedy:	As for alarm 2072
Alarm No.	2081
Alarm Text:	ºCRC not allowedº
Reason:	With TNRC/CRC selected (G41/G42), the following functions cannot
	be programmed:
	G33, G34, G35; G58; G59, G92, M19 S ...
Remedy:	First program cancellation of TNRC/CRC
	with G40 or D0
Alarm No.	2082
Alarm Text:	ºCRC plane not determinableº
Reason:	The axes for the selected CRC/TNRC plane do not exist
Remedy:	Select correct plane with G16
Alarm No.	2087
Alarm Text:	ºCoordinate rotation not allowedº
Remedy:	Check NC program
Alarm No.	2088
Alarm Text	ºBattery alarm abs. submod. 1º
Reason:	Battery voltage is too low. Battery test is performed every 10 min.
Remedy:	Replace battery module on absolute encoder module 1 while the
	control is switched on.
Alarm No.	2089
Alarm Text	ºBattery alarm abs. submod. 2º
Reason:	Battery voltage is too low. Battery test is performed every 10 min.
Remedy:	Replace battery module on absolute encoder module 2 while the
	control is switched on.
Alarm No.	2152
Alarm Text:	ºSpindle speed too highº
Reason:	The actual spindle speed is higher than that set in machine data.
	± Program a smaller S value
	± G92 S ... with v constant
	± Search for a block number in the ºEDITº mode (ºAUTOMATICº
	mode)
Remedy:	Check or inform Service

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-21

SINUMERIK 810T, GA3 (BN)