Siemens 810T manual 2059, 2060, 2061, 2062, 2063

4 Monitoring Functions	01.93
4.6 Listing of the alarms/alarm description

Alarm No.	2059
Alarm Text:	ºG92 program errorº
Reason:	± Use of an invalid address character
	± Error on cylindrical interpolation
Remedy:	G92 is only allowed with address ºSº (programmed spindle speed
	limitation) or ªPº (cylindrical interpolation)
Alarm No.	2060
Alarm Text:	ºTO, ZO program errorº
Reason:	± A non-existent tool offset number was selected
	± The value in the selected zero offset or tool offset is too large
Alarm No.	2061
Alarm Text:	ºGeneral program errorº
Effect:	Inhibiting of NC START
Reason:	± Contour calculation not possible
	± Machine data for ºaxis duplicationº function incorrect
Alarm No.	2062
Alarm Text:	ºFeed missing/not prog.º
Reason:	± No F value programmed
	±	F value too small (machine data)
	±	Feed per rev., G95 greater than 50mm/min per revolution
	±	No feed per rev. programmed
Remedy:	± The axial distance to go for the rotary axis with G98 or G36 is 0 or
		no G98 feed has been programmed.
	Program correct feed
Alarm No.	2063
Alarm Text:	ºThread lead too highº
Reason:	A thread pitch of more than 400 mm/rev.
	(16 inch/rev.) has been programmed.
Effect:	Inhibiting of NC start
Remedy:	Program a smaller thread pitch

4-18 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)