Siemens 810T manual Program input with the keyboard, Sequence, Part Program

3 Operating Sequences 11.90

3.1.10 Program input

3.1.10 Program input

You can input a program

·using the keyboard

·using operator guidance (prompting).

While entering a program using one of the above methods, it is possible to change over to the other method; you can alternate between working with operator prompting and the keyboard.

3.1.10.1 Program input with the keyboard

You enter an opened program %... with the individual blocks N...LF to N...LF character by character only with the keyboard.

Sequence of

and

Call any of the following operating modes:

·PRESET (Actual value setting)

·JOG (Feed/jog)

·AUTOMATIC (Automatic operation)

·INC 1 ... INC 10 000 (Incremental jog)

·REFPOINT (Traverse to reference point)

For this purpose, use the operating mode selection key, and subsequently the relevant softkey (see below) or the operating mode selector switch (external machine control panel).

PART

PROGRAM

Now operate the ºPART PROGRAMº softkey.

Apart from program input, the PART PROGRAM function also serves for:

±Program editing (see Section 3.1.12)

±Program management (see Section 3.1.13)

±Program simulation (see Section 3.1.14).

3-42 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)