Siemens 810T manual ± ªAUTOMATIC passiveº state, ± ªAUTOMATIC activeº state, ± ªJOGº state

3 Operating Sequences 09.91

3.1.9 TRANSMIT coordinate transformation

State / event matrix for transformation selection and deselection:

State				JOG
	Automatic	Automatic			Automatic
Ereignis			JOG	(Automatic
	passive	active			interrupted
				interrupted)
Event
NC Start	Automatic				Automatik
	active				active
NC Stop		Automatic
		interrupted
Change to	JOG	JOG			JOG
JOG		(Automatic			(Automatic
		interrupted)			interrupted)
Change to			Automatic	Automatic
AUTOMATIC			passive	interrupted
RESET	Automatic	Automatic	JOG	JOG	Automatic
	passive	passive			passive
	1)Deselec-	1)Deselec-	1)Deselec-	1)Deselec-	1)Deselec-
	tion of	tion of	tion of	tion of	tion of
	transform.	transform.	transform.	transform.	transform.
Change to
REFPOINT	Deselection	Deselection	Deselection	Deselection	Deselection
	of transform.	of transform.	of transform.	of transform.	of transform.

Note 1)

Case 1: Transformation deselection on RESET: RESET is caused by pressing the RESET key, part programm

(PP) end and mode change except REFPOINT.

Case 2: No transformation deselection on RESET: generally transformation modal except for REFPOINT.

Explanations of the state/event matrix:

The fields within the matrix contain the state subsequent to the event and information on the transformation state.

±ªAUTOMATIC passiveº state:

No program is being executed (Reset).

±ªAUTOMATIC activeº state:

The program is being executed (program running).

±ªJOGº state:

You can traverse manually in the mode ªJOGº, ªINCº or ªREPOSº.

±ªJOGº (AUTOMATIC interrupted) state:

The program was interrupted and the ªJOGº state selected.

±ªAUTOMATIC interruptedº state:

The programm was interrupted, without leaving the ªAUTOMATICº mode (NC Stop).

3-38 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02

SINUMERIK 810T, GA3 (BN)