Siemens 810T manual Influencing ºAUTOMATICº operation

11.90 3 Operating Sequences

3.2.3 Influencing ºAUTOMATICº operation

3.2.3Influencing ºAUTOMATICº operation

Influencing ºAUTOMATICº operation (e.g. through programmed functions), is displayed in the first line of the CRT display.

Display: STOP: AUTO INTERRUPTED

Interruption of ºAUTOMATICº operation (program hold), see Section 3.2.3.4 ºProgram Interruptionº.

Display: HOLD: SINGLE BLOCK

The single block has been processed (with switch position ºSingle block - ONº).

Display: STOP: PROG. STOP M00, M01

Programmed interruption of the program process

with ºProgram startº

processing of the program is continued.

Display: STOP: READ-IN ENABLE

Read enable is a PLC output signal. When the read enable signal is removed, the processing of the current NC block is finished. The next program block is not transferred for processing.

Display: HOLD: DWELL TIME

Processing of the program is interrupted for the duration of the programmed dwell time.

Note:

ºFeed holdº is not displayed on the CRT!

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-93

SINUMERIK 810T, GA3 (BN)