Siemens 810T manual Nc-Md, ªFeed holdº display, ªProgram runningº display

01.93

NC-MD

272*

2 Operation

2.1.1 SINUMERIK 810T operator interface with integrated machine control panel

Press the ºNC-MDº softkey.

Call up MD 272* with this key. Position the cursor on the desired axis

*=0	1st axis
*=1	2nd axis
*=2	3rd axis
*=3	4th axis
*=4	5th axis
*=5	6th axis
*=6	7th axis.

Press the ºModify wordº key.

The new compensation value is shown in the MD:

ªFeed holdº display

The red LED is bright when the feed is interrupted.

The program run is stopped.

ªProgram runningº display

· The green LED is bright when a program is being processed, even if the machine is not moving any axes!

·The LED is extinguished when program processing is completed:

±on programmed Hold M00, M01

±at the end of a single block

±at the end of the program

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 2-5

SINUMERIK 810T, GA3 (BN)