Siemens 810T manual 2184, 2189, 2190, 2191, 2192, 2193

01.93	4 Monitoring Functions
4.6	Listing of the alarms/alarm description

Alarm No.	2184
Alarm Text:	ºM fnct. for C axis invalidº
Alarm No.	2189
Alarm Text:	ºTransformation undefinedº
Reason:	± Type of transformation not defined.
	± Option bit for the transformation not set.
	±	Transformation axes defined multiply or incorrectly.
Remedy:	Press the ªRESETº key.
Alarm No.	2190
Alarm Text:	ºTransformation axes assignedºº
Explanation:	When transformation is selected, one of the real axes of the
	transformation grouping is programmed in another channel (except
	channel 1).
Alarm No.	2191
Alarm Text:	ºTransformation in zeroº
Reason:	A real axis (usually the X axis) is in the zero on selection of transform-
	ation (G131).
Remedy:	Press the ªRESETº key.
Alarm No.	2192
Alarm Text:	ºAxis doubling (duplication) activeº
Reason:	± PLC signals QB 81.2 or QB 81.3 have changed outside the ªReset
		stateº.
	±	Traverse key pressed in ªJOG modeº in ªAUTOMATIC activeº
		state, while PLC signal QB 81.2 or QB 81.3 was active and
		MD 5019.0 set.
	±	While axis duplication is active, the axial PLC signals (servo enable,
		feedrate enable, mirror, follow-up, axis disable) are not the same for
		both axes.
	±	PLC signals QB 81.2 and QB 81.3 at ºZeroº while option bits is set.
Effect:	NC START inihibited.
Remedy:	Set PLC signals correctly.
Alarm No.	2193
Alarm Text:	ºNo additional axes possibleº
Reason:	Only appears when a block search with calculation is initiated in the
	target block and MD "Additional axis after block search with
	calculation" is set, if
		1. additional axes are to be programmed in G36 blocks,
		2. additional axes are to be programmed in G98 blocks which
		have no axes.
Remedy:	For 1. Block search with calculation to program block without G36
	function.
	For 2. Block search with calculation to program block without G98
	function.

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 4-23

SINUMERIK 810T, GA3 (BN)