Freescale Semiconductor SC140 Event Selector ES Registers, Edcd Reference Value Register Edcdref

Event Selector (ES) Registers

4.9.2.2 EDCD Reference Value Register (EDCD_REF)

EDCD_REF is a 32-bit register used to hold a reference value to be compared by the EDCD comparator. EDCD_REF is used by the EDCD comparator. If a byte (8 bits) or a word (16 bits) is to be written into the EDCD_REF, it should be LSB-aligned.

4.9.2.3 EDCD Mask Register (EDCD_MASK)

EDCD_MASK is a 32-bit register that allows the masking of any of the bits in the data bus value that is compared. If bit i in the EDCD_MASK is zero, then it does not participates in the comparison. The data on the bus is ANDed with the EDCD_MASK value, and is then compared with the EDCD_REF register according to the access width. Hence the masked bits must also be zero in the EDCD_REF.

In case that the reference value is 16 or 8 bits long, the mask value must be duplicated 2 or 4 times (respectively) to fill the mask register.

Since data buses are 64 bits, the 32-bit EDCD_MASK register is masked on both 32 LSB and 32 MSB bits of the sampled bus value.

EDCD_MASK is initialized to all ones at reset.

4.10 Event Selector (ES) Registers

ES selects the source for various operations used by the EOnCE. It contains the following registers:

•Event selector control register (ESEL_CTRL)

•Event selector mask debug state register (ESEL_DM)

•Event selector mask debug exception register (ESEL_DI)

•Event selector mask enable trace register (ESEL_ETB)

•Event selector mask disable trace register (ESEL_DTB) The following sections describe these registers.

4.10.1 Event Selector Control Register (ESEL_CTRL)

The 8-bit control register ESEL_CTRL controls the operation of the ES, which is programmed in the following order:

1.Reset the event selector mask registers.

2.Program the ESEL_CTRL register.

3.Program the appropriate event selector mask registers.

SC140 DSP Core Reference Manual 4-61