D-Link DGS-3700 user manual CFM Loopback Settings, Mip, Mep, Lbm

	DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
MIP	This setting controls the creation of MIPs.
	None – Means that no MIPs will be created. This is the default value.
	Auto – MIPs are created when the next lower active MD-level on the port is reached or there are
	no lower active MD levels.
	Explicit – MIPs are created when the next lower active MD-level on the port is reached.
SenderID TLV	Used to define the TLV data types of the maintenance domain. The user can choose between
	None, Chassis, Manage or Chassis Manage.

To create a new entry enter the appropriate information and click Add. To configure the settings enter the appropriate information and click Apply.

CFM Loopback Settings

This window is used to configure the CFM Loopback settings on the Switch.

To view this window, click L2 Features > CFM > CFM Loopback Settings as shown below:

		Figure 3 - 83 CFM Loopback Settings window
The following parameters can be configured:
Parameter		Description
MEP	Name	The name of the Maintenance End Point.
(Max:32
characters)
MEP ID (1-8191)		The ID for the Maintenance End Point between 1 and 8191.
MD	(Max:22	The Maintenance Domain Name.
characters)
MA	(Max:22	The Maintenance Association Name.
characters)
MAC Address		The destination MAC address.
LBMs Number (1-		The number of LBMs to be sent the default value is 4.
65535)
LBM	Payload	The payload length of the LBM to be sent, the default value is O.
Length (0-1500)
LBM	Payload	The arbitary amount of data to be included in a Data TLV, along with the indication of whether
Pattern		the Data TLV is to be included.
(Max:1500
characters)
		126