D-Link DGS-3700 user manual Access Profile Packet Content

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

	Figure 6 - 25 Access Profile (Packet Content)
The following parameters may be configured for the Packet Content filter.
Parameter	Description
Access ID (1-128)	Type in a unique identifier number for this access. This value can be set from 1 to 128.
Action	Select Permit to specify that the packets that match the access profile are forwarded by the
	Switch, according to any additional rule added (see below).
	Select Deny to specify the packets that match the access profile to be filtered.
	Select Mirror to specify that packets that match the access profile are mirrored to a port
	defined in the config mirror port command. Port Mirroring must be enabled and a target port
	must be set.
Priority (0-7)	Enter a priority value if you want to re-write the 802.1p default priority of a packet to the
	value entered in the Priority field, which meets the criteria specified previously in this
	command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
	its incoming 802.1p user priority re-written to its original value before being forwarded by the
	Switch.
Replace DSCP	Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
	the selected criteria) with the value entered in the adjacent field.
Replace ToS	Select this option to instruct the Switch to replace the Type of Service as part of the packet
Precedence	header.
Chunk	This field will instruct the Switch to mask the packet header beginning with the offset value
	specified.
Rx Rate (1-15624)	Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
	using the following equation: 1 value = 64Kbit/sec. (ex. If the user selects an Rx rate of 10
	then the ingress rate is 640Kbit/sec.) The user many select a value between 1 and 15624 or
	tick the No Limit check box. The default setting is No Limit.
Time Range Name	Tick the check box and enter the name of the Time Range settings that has been previously
	configured in the Time Range Settings window. This will set specific times when this
	access rule will be implemented on the Switch.

204