DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
198
Figure 6 - 16 Add IPv6 ACL Profile
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuratio n. To c reate a
new entry enter the correct information and click Create. To return to the Ac cess Profile List page click Back.
The following parameters can be set, for IPv6:
Parameter Description
IPv6 Class Ticking this check box will instruct the Switch to examine the class field of the I Pv6 header.
This class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
IPv6 Flow Label Ticking this check box will instruct the Switch to examine the flow label field of the IPv6
header. This flow label field is used by a source to label seque nces of pack ets such as non-
default quality of service or real time service packets.
IPv6 TCP Ticking this check box will specify that the rule applies t o TCP traffic.
The user can enter a specific TCP Source Port Mask or TCP Destination P ort Mask.
IPv6 UDP Ticking this check box will specify that the rule applies t o UDP traffic.
The user can enter a specific UDP Source Port Mask or UDP Destination Por t Mask.
IPv6 Address IPv6 Source Address – Enter an IPv6 address to be used as the source address mask.
IPv6 Destination Address – Enter an IPv6 address that will be used as the destination
address mask.
NOTE: At any one time the user can only choose IPv6 class and
IPv6 Flow Label together or IPv6 Address by itself.
Click Apply to implement changes made.