D-Link DGS-3700 Web-based Access Control User Settings, Logout Timer, Authentication, Redirection

	DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
		for users trying to access the network via the switch. This RADIUS server must have already
		been pre-assigned by the administrator using the RADIUS Server window located in the
		802.1X section.
Logout Timer		The logout time in displayed in minutes, enter a value between 1 and 1440.
(1-1440)
Authentication		Enter the VLAN name which users will be placed while authenticated by the Switch or a
VLAN		RADIUS server. This VLAN should be pre-configured to have limited access rights to web
		based authenticated users.
Redirection Page		Enter the URL of the website that authenticated users placed in the VLAN are directed to once
		authenticated. This path must be entered into this field before the Web-based Access Control
		can be enabled.
Port List		Specify the ports to be enabled as Web-based Access Control ports. Only these ports will
		accept authentication parameters from the user wishing limited access rights through the
		Switch. When one client on a port has been authenticated for Web-based Access Control, all
		clients on this port are authenticated as well.
		Use the State pull-down menu to enable these configured ports as Web-based Access Control
		ports.

Click Apply to implement changes made.

NOTE: To enable the Web-based Access Control function, the redirection path field must have the URL of the website that users will be directed to once they enter the limited resource, pre- configured VLAN. Users who attempt to Apply settings without the Redirection Page field set will be prompted with an error message and Web-based Access Control will not be enabled. The URL should follow the form http(s)://www.dlink.com

NOTE: The subnet of the IP address of the authentication VLAN must be the same as that of the client, or the client will always be denied authentication.

NOTE: A successful authentication should direct the client to the stated web page. If the client does not reach this web page, yet does not receive a Fail! message, the client will already be authenticated and therefore should refresh the current browser window or attempt to open a different web page.

Web-based Access Control User Settings

This window is used to configure the Switch for Web Authentication Settings.

To view this window, click Security > Web Authenication > Web-based Access Control User Settings as shown below:

Figure 5 - 47 Web-based Access Control User Settings window

The following parameters may be configured:

ParameterDescription

Create User

185