D-Link DGS-3700 Parameter Description Interface Name, IPv6 Network, Address, IPv6 State, Time

Description

Displays the interface being edited.

Enter the name of the VLAN corresponding to the interface.

Enter an alternative IPv4 address. Currently an interface can only have one IPv4 address defined. Therefore multinetting configuration of IPv4 must be done through creation of a secondary interface on the same VLAN, instead of directly configuring multiple IPv4 addresses on the same interface.

Enter the corresponding subnet mask.

This function allows user to enable the IPv4 address on the IP interface.

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

Enter the new VLAN Name and Admin. State and click Apply. To edit an entry for IPv4 features click the corresponding IPv4 Edit button.

Figure 2 - 7 IPv4 Interface Settings Edit window

The following parameters can be configured:

Parameter

Interface Name

VLAN Name

IPv4 Address

Subnet Mask

IPv4 State

Click Apply to implement changes made.

To edit an entry for IPv6 features click the corresponding IPv6 Edit button.

		Figure 2 - 8 IPv6 Interface Settings Edit window
The following parameters can be configured:
Parameter		Description
Interface Name		Displays the interface being edited.
VLAN Name		Enter the name of the VLAN corresponding to the interface.
IPv6	Network	Enter the IPv6 Network Address to be configured. The interface can have multiple IPv6 addresses
Address		defined. Configuration of IPv6 addresses must be done through the command config ipif.
IPv6 State		Allows the user to enable or disable the IPv6 state on the interface.
NS	Retransmit	This field is used to set the interval, in milliseconds that the Switch will produce neighbor
time	(0-	solicitation packets to be sent out over the local network. This is used to discover IPv6 neighbors
4294967295)		on the local network. The user may select a time between 0 and 4294967295 milliseconds. The
		default is 0.
		12