D-Link DGS-3700 user manual Mode

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

Access ID (1-128)Enter the Access ID that will be used to configure the Flow Metering parameters, enter a value
	between 1 and 128.
Mode	Select the mode to be used either trTCM or srTCM and enter the corresponding information.
	trTCM – Two Rate Three Color Marker, marks packets green, yellow or red based on two rates
	and two burst sizes. It is useful when peak rates need to be enforced.

•CIR(64Kbps) value 0-15624– Specifies the Committed Information Rate of the packet. The unit is 64Kbps. That is to say, 1 means 64Kbps.

•PIR(64Kbps) value 0-15624– Specifies the Peak Information Rate of the packet. The unit is 64Kbps. That is to say, 1 means 64Kbps.

•CBS(Kbyte) value 0-16384– Specifies the Committed Burst Size of the packet. The unit is Kbyte. That is to say, 1 means 1Kbyte. This parameter is optional and the default value is 4*1024. The max value is 16*1024.

•PBS(Kbyte) value 0-16384– Specifies the Peak Burst Size of the packet. The unit is Kbyte. That is to say, 1 means 1Kbyte. This parameter is optional and the default value is 4*1024. The max value is 16*1024.

srTCM – Single Rate Three Color Marker, marks packets green, yellow or red based on a rate and two burst sizes. This is useful when only burst size matters.

•CIR(64Kbps) value 0-15624– Specifies the Committed Information Rate of the packet. The unit is 64Kbps. That is to say, 1 means 64Kbps.

•CBS(Kbyte) value 0-16384– Specifies the Committed Burst Size of the packet. The unit is Kbyte. That is to say, 1 means 1Kbyte. The maximum value is 16*1024.

•EBS(Kbyte) value 0-16384– Specifies the Excess Burst Size of the packet. The unit is Kbyte. That is to say, 1 means 1Kbyte. The maximum value is 16*1024.

Action	Conform – Specifies the action when the packet is in “green color” mode.
	• Replace DSCP – Allows you to change the dscp of the packet
	• Counter – Allows you to set the counter of the packet.
	Exceed – Specifies the action when the packet is in “yellow color” mode.
	• Permit – Permits the packet.
	• Replace DSCP – Allows you to change the DSCP of the packet.
	• Counter – Allows you to set the counter of the packet.
	• Drop – Drops the packet.
	Violate – Specifies the action when the packet is in “red color” mode.
	• Permit – Permits the packet.
	• Replace DSCP – Allows yout to change the DSCP of the packet.
	• Counter – Allows you to set the counter of the packet.
	• Drop – Drops the packet.

Click Apply to implement changes made, click Back to return to the ACL Flow Meter.

219