|
|
| |
|
|
|
|
|
| otherwise configured by the user. |
|
|
|
|
|
| Version | States the firmware version. |
|
|
|
|
|
| Size (Bytes) | States the size of the corresponding firmware, in bytes. |
|
|
|
|
|
| Update Time | States the specific time the firmware version was downloaded to the Switch. |
|
|
|
|
|
| From | States the IP address of the origin of the firmware. There are five ways firmware may be |
|
|
| downloaded to the Switch. |
|
|
| R – If the IP address has this letter attached, it denotes a firmware upgrade through the serial |
|
|
| port RS232. |
|
|
| T – If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet. |
|
|
| S – If the IP address has this letter attached to it, it denotes a firmware upgrade through the |
|
|
| Simple Network Management Protocol (SNMP). |
|
|
| W – If the IP address has this letter attached to it, it denotes a firmware upgrade through the |
|
|
|
| |
|
| SSH – If the IP address has these three letters attached, it denotes a firmware update through |
|
|
| SSH. |
|
|
| SIM – If the IP address has these letters attached, it denotes a firmware upgrade through the |
|
|
| Single IP Management feature. |
|
|
|
|
|
| User | States the user who downloaded the firmware. This field may read “Anonymous” or “Unknown” |
|
|
| for users that are unidentified. |
|
|
|
|
|
Dual Configuration Settings
The following window is used to configure firmware information set in the Switch. The
To view this window, click Configuration > Dual Configuration Settings as shown below:
Figure 2 - 37 Dual Configuration Settings
This window displays the following information:
Parameter Description
ID | States the ID number of the configuration file located in the Switch’s memory. The Switch can |
| store two configuration files for use. ID 1 will be the default boot up configuration file for the |
| Switch unless otherwise configured by the user. |
|
|
Version | Displays the firmware version set in the Switch. |
|
|
| 32 |
