
|
|
| ||
|
|
|
|
|
|
|
| Switch |
|
|
|
|
|
|
| Replace DSCP |
| Select this option to instruct the Switch to replace the DSCP value (in a packet that meets |
|
|
|
| the selected criteria) with the value entered in the adjacent field. |
|
| Replace ToS |
| Select this option to instruct the Switch to replace the Type of Service as part of the packet |
|
| Precedence |
| header. |
|
| VLAN Mask |
| Allows the entry of a name for a previously configured VLAN. |
|
|
|
|
|
|
| VLAN ID |
| Allows the entry of a VLAN ID for a previously configured VLAN. |
|
|
|
|
|
|
| DSCP |
| Selecting this option instructs the Switch to examine the DiffServ Code part of each packet |
|
|
|
| header and use this as the criteria, or part of the criterion for forwarding. |
|
| ICMP |
| Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP) |
|
|
|
| field in each frame's header. |
|
| Rx Rate |
| Use this to limit Rx bandwidth for the profile being configured. This rate is implemented |
|
|
|
| using the following equation: 1 value = 64Kbit/sec. (ex. If the user selects an Rx rate of 10 |
|
|
|
| then the ingress rate is 640Kbit/sec.) The user many select a value between 1 and 15624 or |
|
|
|
| tick the No Limit check box. The default setting is No Limit. |
|
| Time Range Name |
| Tick the check box and enter the name of the Time Range settings that has been previously |
|
|
|
| configured in the Time Range Settings window. This will set specific times when this |
|
|
|
| access rule will be implemented on the Switch. |
|
| Counter |
| Enable or disable the counter settings. |
|
|
|
|
|
|
| Ports |
| Specifies that the access rule will take effect on one port or a range of ports. |
|
|
|
|
|
|
| VLAN Name |
| Specifies the access rule will take effect on the VLAN Name specified. |
|
| VLAN ID |
| Specifies the access rule will take effect on the VLAN ID specified. |
|
Click Apply to display the following Access Rule List window.
Figure 6 - 14 Access Rule List (IPv4)
To view the configurations for previously configured rule click on the corresponding Show Details Button which will display the following Access Rule Details window.
Figure 6 - 15 Access Rule Detail Information
To configure the IPv6 ACL select IPv6 in the Add ACL Profile window, enter the Profile ID and Profile Name into the top half of the screen in the Add ACL Profile window and click Select, the following window will appear.
197