
| Figure 6 - 7 Access Profile Ethernet |
|
To set the Access Rule for Ethernet, adjust the following parameters and click Apply. |
| |
|
|
|
Parameter | Description |
|
|
|
|
Access ID | Type in a unique identifier number for this access. This value can be set from 1 to 128. |
|
| Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID |
|
| for the rule being created. |
|
|
|
|
VLAN Mask | Allows the entry of a VLAN Mask for a previously configured VLAN. |
|
|
|
|
VLAN ID | Allows the entry of a VLAN ID for a previously configured VLAN. |
|
|
|
|
802.1p | Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this |
|
| 802.1p priority value. |
|
Action | Select Permit to specify that the packets that match the access profile are forwarded by the |
|
| Switch, according to any additional rule added (see below). |
|
| Select Deny to specify the packets that match the access profile are not forwarded by the Switch |
|
| and will be filtered. |
|
| Select Mirror to specify that packets that match the access profile are mirrored to a port defined |
|
| in the config mirror port command. Port Mirroring must be enabled and a target port must be set. |
|
|
|
|
Priority | Enter a priority value if you want to |
|
| entered in the Priority field, which meets the criteria specified previously in this command, before |
|
| forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming 802.1p |
|
| user priority |
|
| For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS |
|
| section of this manual. |
|
|
|
|
Replace Priority | Enter a replace priority manually if you want to |
|
| the value entered in the Priority field, which meets the criteria specified previously in this |
|
| command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its |
|
| incoming 802.1p user priority |
|
Replace DSCP (0- | Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the |
|
63) | selected criteria) with the value entered in the adjacent field. |
|
Replace ToS | Select this option to instruct the Switch to replace the Type of Service as part of the packet |
|
192