DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

Figure 6 - 4 Add Ethernet ACL Profile window

Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a new entry enter the correct information and click Create. To return to the Access Profile List page click Back.

The following parameters can be configured.

Parameter

Description

 

 

Ethernet ACL

To configure this profile select the Ethernet ACL, and use the drop down menu to choose

 

between tagged or untagged.

 

 

Source MAC Mask

Enter a MAC address mask for the source MAC address.

 

 

Destination MAC

Enter a MAC address mask for the destination MAC address.

Mask

 

 

 

Select ACL Type

Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 or packet content

 

mask. This will change the menu according to the requirements for the type of profile.

 

Select Ethernet to instruct the Switch to examine the layer 2 part of each packet

 

header.

 

Select IPv4 to instruct the Switch to examine the IPv4 address in each frame's

 

header.

 

Select IPv6 to instruct the Switch to examine the IPv6 address in each frame’s

 

header.

 

Select Packet Content Mask to specify a mask to check the content of the packet

 

header.

802.1Q VLAN

Selecting this option instructs the Switch to examine the VLAN identifier of each packet

 

header and use this as the full or partial criterion for forwarding.

 

 

802.1P

Selecting this option instructs the Switch to examine the 802.1p priority value of each packet

 

header and use this as the, or part of the criterion for forwarding.

 

 

190

Page 201
Image 201
D-Link DGS-3700 Parameter Description Ethernet ACL, Source MAC Mask, Destination MAC, Mask Select ACL Type, 802.1Q Vlan