DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
49
timeout value will become 400 automatically.
Timeout (1-2000000) The length of time before the server is timed out. When the analyzer server times out, all
of the flow samplers and counter pollers associated with this analyzer server will be
deleted. “Infinite” indicates that the analyzer server will nev er time out. If not specified, the
default value is 400.
Collector Address The IP address of the analyzer server. If not specified, the address will be 0.0.0. 0 which
means that the entry will be inactive.
Collector Port (1-65535) The destination UDP port for sending the sFlow datagrams. If not s pecified, the default
value is 6364.
Max Datagram size
(300-1400) The maximum number of data bytes that can be packed in a single sample datagram. If not
specified, the default value is 1400.
Click Apply to implement the changes made.
sFlow Flow Sampler Settings
This table is used to create sFlow flow sampler settings on the Switch. By config u ring the s am pling functi on for a port,
a sample packet received by this port will be encapsulated and forwarded to the anal yzer server at the specified
interval.
To view this window, click Configuration > sFlow > sFlow Flow Sampler Settings as shown below:
Figure 2 - 57 sFlow Flow Sampler Settings window
The following parameters can be configured:
Parameter Description
From Port / To Port Specifies the port or list of ports to be configured.
Analyzer Server ID (1-
4) The analyzer server id specifies the ID of a server analyzer where the packet will be
forwarded.
Rate (0-65535) The sampling rate for packet sampling. The actual rate is the configured ra te value
multiplied by 256. For example, if the rate is 20, the actual rate 5120. One packet will be
sampled from about 5120 packets. If set to 0, the sampler is disabled. If the rate is not
specified, its default value is 0.
MAX Header Size (18-
256) The maximum number of leading bytes in the packet which will be sam pled, enc apsulated
and forwarded to the server. If not specified, the default value is 128.
Click Apply to implement the changes made.