DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
26
DHCP Relay Interface Settings
This window allows the user to set up a server, by IP ad dress, f or rela ying DHC P infor mation t o the S witch. T he user
may enter a previously configured IP interface on the Switch t hat will be connected directly to the DH CP/BOOTP
server using the following window. Properly configured settings will be displayed in the D HCP Relay Interface Table
at the bottom of the following window. The user may add up to four server IP’s per IP interface on the Switch.
To view this window, click Configuration > DHCP Relay > DHCP Relay Interface Settings as shown below:
Figure 2 - 22 DHCP Relay Interface Settings and DHCP Relay Interface Table window
The following parameters may be configured or viewed:
Parameter Description
Interface The IP interface on the Switch that will be connected directl y to the Server.
Server IP Enter the IP address of the DHCP server. Up to four server IPs can be configured per IP
Interface.
Click Apply to implement changes made.
DHCP Relay Option 60 Default Settings
This window allows the user to configure the DHCP Relay Option 60 Default servers. When there are no matching
servers found for the packet based on option 60, the relay servers will be determined by the defaul t relay server
setting. Similiarly when there is no match found for the packet, the re lay servers will be determined base d on the
default relay servers.
To view this window, click Configuration > DHCP Relay > DHCP Relay Option 60 Default Settings as shown
below:
Figure 2 - 23 DHCP Relay Option 60 Default Settings window
The following parameters may be configured:
Parameter Description
Relay IP Address Enter the specified IP address for the DHCP relay for ward.
Mode Use the pull down menu to choose either Relay or Drop. When drop is s pecified, the pack et
with no matching rules found will be dropped without further process . W hen r ela y is selected
the packet will be relayed based on the relay rules.
Click Add to add a new Relay IP A ddress entry. Click Apply to implem ent changes made. To remove any entries click
the corresponding Delete button.