
Figure 6 - 10 Add IPv4 ACL Profile
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a new entry enter the correct information and click Create. To return to the Access Profile List page click Back.
The following parameters can be set, for IP:
Parameter | Description |
|
|
VLAN | Selecting this option instructs the Switch to examine the VLAN part of each packet header |
| and use this as the, or part of the criterion for forwarding. |
|
|
DSCP | Selecting this option instructs the Switch to examine the DiffServ Code part of each packet |
| header and use this as the, or part of the criterion for forwarding. |
|
|
Source IP Mask | Enter an IP address mask for the source IP address. |
|
|
Destination IP Mask | Enter an IP address mask for the destination IP address. |
|
|
ICMP Type | • icmp – Specifies that the Switch will examine the Internet Control Message Protocol |
| (ICMP) field within each packet. |
| • type <value |
| packet. |
| • code <value |
| packet. |
|
|
Protocol | Selecting this option instructs the Switch to examine the protocol type value in each frame's |
| header. You must then specify what protocol(s) to include according to the following |
| guidelines: |
| Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP) |
| field in each frame's header. |
| Select Type to further specify that the access profile will apply an ICMP type |
| value, or specify Code to further specify that the access profile will apply an ICMP |
194