D-Link DGS-3700 user manual Class, Flow Label

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

	Figure 6 - 19 Access Profile (IPv6)
The following parameters may be configured for the IP (IPv6) filter.
Parameter	Description
Access ID (1-128)	Enter a unique identifier number for this access. This value can be set from 1 to 128.
Class	Specifies the IPv6 Class. Enter a value between 0 – 255.
Flow Label	Specifies the IPv6 Flow Label. Enter a value between 0 – FFFFF.
Action	Select Permit to specify that the packets that match the access profile are forwarded by the
	Switch, according to any additional rule added (see below).
	Select Deny to specify the packets that match the access profile to be filtered.
	Select Mirror to specify that packets that match the access profile are mirrored to a port
	defined in the config mirror port command. Port Mirroring must be enabled and a target port
	must be set.
Priority (0-7)	Enter a priority value if you want to re-write the 802.1p default priority of a packet to the
	value entered in the Priority field, which meets the criteria specified previously in this
	command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
	its incoming 802.1p user priority re-written to its original value before being forwarded by the
	Switch.
Replace Priority	Enter a replace priority manually if you want to re-write the 802.1p default priority of a packet
	to the value entered in the Priority field, which meets the criteria specified previously in this
	command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
	its incoming 802.1p user priority re-written to its original value before being forwarded by the
	Switch
Replace DSCP	Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
	the selected criteria) with the value entered in the adjacent field.
Replace ToS	Select this option to instruct the Switch to replace the Type of Service as part of the packet
Precedence	header.
Class	Entering a class will instruct the Switch to examine the class field of the IPv6 header. This
	class field is a part of the packet header that is similar to the Type of Service (ToS) or

200