DIAL BY NAME
To register a name and number for call by Speed
1.From the idle state, press the STA soft key.
2.Using the UP or DOWN soft keys, select the buffer number to be programmed.
3.Press the FEATURE key.
4.Using the Alphabet on keys 2 through 9, assign the name first. (Refer to Service Condition #2.)
5.Press the FEATURE key to program the number.
6.Dial the internal station number or the trunk access code (i.e., 9); then dial the outside number.
7.Press the FEATURE key. “SET” will appear on the display.
Service Conditions
1.Service
a.Up to 32 Multiline Terminals are available to use this feature at the same time.
b.The Multiline Terminal returns to idle status after the ten seconds from pressing SYS/STA key and no key operation is activated.
c.If the speed calling memory block is not assigned to the Multiline Terminal, the SYS/STA key is not affected when the Multiline Terminal user presses these keys.
d.This service feature is ended or interrupted by pressing the Hold key.
e.When the Multiline Terminal uses this feature, the incoming call to My Line is rejected.
f.When the Multiline Terminal uses this feature, the incoming call to
g.When the Multiline Terminal uses this feature and the user dials the Line/Trunk/Answer key, this feature is ended and Line/Trunk/Answer key is activated.
h.When the Multiline Terminal is in this service, pressing the Recall, Transfer, and Conf key are not affected.
i.Up to eight Multiline Terminals can use the Help key at the same time.
j.The explanation displayed by the Help key will automatically be cleared unless the Exit key is pressed for 16 to 20 seconds.
NEAX2000 IVS2 |
|
Business/Hotel/Data Features and Specifications | Page 131 |
