NEC NEAX 2000 specifications Attendant Console, SN610 Attcon

ATTENDANT CONSOLE

SN610 ATTCON

ATTENDANT CONSOLE

SN610 ATTCON

General Description

The Attendant Console (SN610 ATTCON) operates on a switched-loop basis with a maximum of 6 Attendant loops terminating at each console on the associated interface card. The Attendant uses these loops for answering, originating, holding, extending, and re-entering calls. When Attendant loop release is used, the number of loops is effectively increased to a maximum of 12 for each console. The following pages describe the features asso- ciated with the Attendant Console.

An alternate Attendant Position is described under Multiline Terminal Attendant Position.

Station Application

Attendant Console (SN610 ATTCON).

Operating Procedure

Detailed operating procedures are provided in Attendant Console User’s Guide.

Service Conditions

1.Each Firmware Processor (FP) can support up to 8 Attendant Consoles (SN610 ATTCON/SN716 DESKCON). A maximum of 8 Attendant Consoles (SN610 ATTCON/SN716 DESKCON) can be support- ed per system.

2.Each Attendant Console requires a 2-pair cable. This cable cannot be longer than 4000 feet (1200 meters).

SN716 DESKCON

General Description

The Attendant Console (SN716 DESKCON) operates on a switched-loop basis with a maximum of 6 Attendant loops terminating at each console on the associated Interface card. The Attendant uses these loops for answering, originating, holding, extending, and re-entering calls. When Attendant loop release is used, the number of loops is effectively increased to a maximum of 12 for each console.

For the applicable features and specifications associated with the SN716 DESKCON, refer to the following pag- es which describe the SN610 ATTCON features and specifications.

Station Application

Attendant Console (SN716 DESKCON).

Operating Procedure

The same operating procedures as the SN610 ATTCON are applied for each feature.

	NEAX2000 IVS2
Page 20	Business/Hotel/Data Features and Specifications
	NDA-24271, Issue 1.0